Valve Cover: Service and Repair

Valve cover

Operation number: 21144-2

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Remove the inner timing cover. Refer to: Gasket, inner timing cover, B6324S Gasket, Inner Timing Cover.














Caution! Take extra care not to damage the mating faces.





Installation

Caution! Make sure that the mating faces are clean and free of foreign material.

Caution! Make sure that the cylinder head screw's threaded holes in the engine block are free of fluid.

Use: gasket solution, 1161 440

Thoroughly blow clean the oil ducts in the cylinder head.





Caution! Ensure that no liquid gasket gets into the oil ducts.

Fit new O-rings around the spark plug sockets.
951 2767 Roller 951 2767 Roller

Use: liquid gasket, 116 1059

Apply fluid gasket to the camshaft cover. The surface should be fully covered with no excess.




Make sure that the choke valves (1) and (2) are in place.







Turn the camshafts into position.




Oil in the camshaft nodes, camshaft bearing surfaces and the top of the valve lifters. Fit the camshaft cover. Screw in all screws in a manner that the cover remains parallel to the cylinder head.
Using the sequence 1-9, tighten the camshaft cover to the cylinder head alternately a few turns at a time until there is full contact. Tighten other screws by hand.




Tighten the screws in the sequence 1-27.
M7. Refer to Specifications, B6324S Tightening Torque




Tighten the screws in the sequence 28-60.
M7. Refer to Specifications, B6324S Tightening Torque











Fit the inner timing cover. Refer to: Gasket, inner timing cover, B6324S Gasket, Inner Timing Cover.