Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSVOLVO2007XC90 AWD L6-3.2L VIN 98 B6324SREPAIR AND DIAGNOSISBODY AND FRAMELOCKSDOOR LOCKSSERVICE AND REPAIRLOCK MECHANISM REAR SIDE DOOR, REPLACING

2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324S

Lock Mechanism Rear Side Door, Replacing

2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324SSECTION Lock Mechanism Rear Side Door, Replacing

Lock mechanism rear side door, replacing

The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removing the lock mechanism for the rear side door
The window must be closed before beginning removal.

Remove:
- the door panel. See Panel rear side door, replacing Panel Rear Side Door, Replacing
- the run-off profile
- the link for the inner lock button
- the link for the external handle
- the 3 screws.
Lift the lock out of the door.
Remove the connector.
Unhook the cable.
Remove the cover from the top of the lock.

Installing the lock mechanism for the rear side door

Note! For tightening torques, see Specifications [1][2]Body and Frame.

Press down the cover (1) on the top of the lock.
Press in the locking plug (2).
Hook the cable into place.
Connect the connector.
Lift the lock into the door.

Install:
- the 3 M6 screws. Tighten
- the link for the external handle
- the link for the inner lock button
- the run-off profile
- the door panel. See Panel rear side door, replacing Panel Rear Side Door, Replacing.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.