Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD L6-3.2L VIN 98 B6324SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONP CODE CHARTSP1250DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324S
Diagnostic Trouble Code (DTC) Information
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-P125000
Condition
The engine control module (ECM) checks the function in the throttle unit When switching off the engine a mechanical function check of the electronic throttle module (ETM) is carried out where the throttle disc spring is moved to the open position (open throttle). When control has finished, the time it takes for the damper to return to the return rest position is measured.
If Engine Control Module (ECM) detects that the throttle movement does not take place within reasonable time, the diagnostic trouble code is generated.
The diagnostic trouble code can be diagnosed when function check is performed.
Substitute value
- Nothing.
Possible source
- The throttle binds or is blocked (for example, dirt, ice, etc.)
- Damaged electronic throttle unit.
Fault symptom[s]
- Poor performance.
- Uneven idle.
- Message in information display
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.