Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD L6-3.2L VIN 98 B6324SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONP CODE CHARTSP0481DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324S
Diagnostic Trouble Code (DTC) Information
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-P048100
Condition
The engine control module (ECM) sends a signal (speed request to the cooling fan) to the cooling fan module. The cooling fan module then regulates voltage to the fan motor at an infinitely variable rate. The diagnostic trouble code is generated if the engine control module (ECM) detects that fan speed is low.
The diagnostic trouble code can be diagnosed when the engine is running.
Note! The electric cooling fan may have a post-running time of up to approx. 6 minutes after the engine has been shut off. The time for the electric cooling fan's post-running depends on the engine's temperature, temperature in the engine compartment as well as the pressure level in the AC system.
Substitute value
- Nothing.
Possible source
- The cooling fan control module detects that the voltage feed is too high or too low.
Fault symptom[s]
- None
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.