Configuration Fault

2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324SSECTION Configuration Fault





Configuration fault

Re-configuration




- The configuration of the siren does not correspond to the configuration of the car
- Ignition on
- Click the VCT2000 symbol to re-configure the siren.





Continue - Reading off diagnostic trouble codes (DTC)

-------------------------------------------------

Reading off diagnostic trouble codes (DTC)




- Ignition on.




- Read off diagnostic trouble codes (DTCs).

Has diagnostic trouble code (DTC) UEM-0078 been stored again?

Yes - Replacing the component

No - FAULT FOUND

-------------------------------------------------

Replacing the component




- A faulty siren is installed
- Replace the siren. See Siren, replacing Service and Repair
- Ignition on.
Activate the configuration.





Continue - FAULT FOUND

-------------------------------------------------

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.