Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD L6-3.2L VIN 98 B6324SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSCCM CODES (CLIMATE CONTROL MODULE)CCM-0011INTERNAL FAULT
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324S
Internal Fault
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324SSECTION Internal Fault
Internal fault
Replacing the component
The climate control module (CCM) has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults may be caused by interference at start up of the climate control module (CCM). Intermittent faults may also be caused by other types of intermittent faults. The fault is evaluated depending on how it occurs. If the fault recurs, replace the climate control module (CCM).
Replace the climate control module (CCM) in the event of a permanent fault:
Climate control module (CCM), replacing Service and Repair
Remedy as necessary.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.
Do you want to view the information again?
Yes - Attempt New Test
No - Exit Fault-Tracing
------------------------
Attempt New Test - Replacing the component
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.