Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD L6-3.2L VIN 98 B6324SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONC CODE CHARTSC0102DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324S
Diagnostic Trouble Code (DTC) Information
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information SAS-C010229
Condition
The Steering Angle Sensor (SAS) is located in the Steering Wheel Module (SWM) from which it is supplied with power. It is however only the Steering Angle Sensor which communicates on the Control Area Network (CAN).
Fitted into the Steering Angle Sensor (SAS) is a code wheel which follows the steering wheel rotation. Nine optical digital sensors and two analogue photo diodes read the code from the wheel. The code signals which are generated shall form a specific pattern. If the Steering Angle Sensor (SAS) registers that one or both of the signals from analogue photo-diodes 1 and 2 are faulty, the trouble code is set.
The trouble code may be diagnosed when the ignition is on and the angle sensor is initiated. The sensor is initiated by the steering wheel being turned by more than 4.5° in either direction.
Substitute value
- The stability function is blocked.
Possible source
- Internal fault in the Steering Angle Sensor (SAS).
Fault symptom[s]
- The anti-spin warning lamp is illuminated.
- General warning lamp lit
- The stability function is not working.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.