Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD L6-3.2L VIN 98 B6324SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONC CODE CHARTSC0096DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324S
Diagnostic Trouble Code (DTC) Information
2007 Volvo XC90 AWD L6-3.2L VIN 98 B6324SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information SAS-C009687
Condition
The control modules transmit and receive information via a standardized communication network, CAN (Control Area Network). If the Steering Angle Sensor (SAS) registers that information from the Central Electronic Module (CEM) is missing then the trouble code is set.
The Steering Angle Sensor (SAS) is located in the Steering Wheel Module (SWM) from which it is supplied with power. It is however only the Steering Angle Sensor which communicates on the Control Area Network (CAN).
Substitute value
- The stability function is blocked.
Possible source
- Faulty information from the Central Electronic Module (CEM).
Fault symptom[s]
- The anti-spin warning lamp is illuminated.
- General warning lamp lit
- The stability function is not working.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.