Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007V50 L5-2.4L VIN 38 B5244S4REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRPASSENGER DOOR MODULE (PDM)
2007 Volvo V50 L5-2.4L VIN 38 B5244S4
Passenger Door Module (PDM)
2007 Volvo V50 L5-2.4L VIN 38 B5244S4SECTION Passenger Door Module (PDM)
Passenger door module (PDM)
Operation number: 36445-2
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Preparatory work
Information
Caution! New software can only be ordered when the new control module is installed in the vehicle. The new control module identity is read off by VIDA with ordering, which is required for ordering the correct software.Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the cause of the fault.
Ignition off
Ignition off
Removal
Removing the passenger door module (PDM)
Caution! Passenger door module (PDM) and the electric motor may not be parted.
Remove the control module and electric motor according to: Electric motor, lift mechanism, front door Service and Repair Electric motor, lift mechanism, front door Service and Repair.
Installation
Installing the passenger door module (PDM)
Caution! Check that the control module connectors are intact.
Fit the control module and electric motor according to: Electric motor, lift mechanism, front door Service and Repair Electric motor, lift mechanism, front door Service and Repair.
Finishing
Ordering software
Order software for the control module. See: 30669923.
Initializing the window position
Initiate the window's position, see: VIDA Vehicle communication.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.