Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007V50 L5-2.4L VIN 38 B5244S4REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSELECTRONIC THROTTLE CONTROL MODULESERVICE AND REPAIR
2007 Volvo V50 L5-2.4L VIN 38 B5244S4
Electronic Throttle Control Module: Service and Repair
2007 Volvo V50 L5-2.4L VIN 38 B5244S4SECTION Service and Repair
Throttle Body (Electronic Throttle Module (ETM)), Replacing
NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
Preparatory work
Removing components
Remove the battery ground lead.
Remove the air cleaner (ACL) module.
Removal
Removing the throttle body (TB)
Disconnect the connector for the throttle body (TB).
Remove:
- the screws for the throttle body (TB). Lift out the throttle body (TB).
Installation
NOTE: For tightening torques, see Tightening torque.
Installing the throttle body (TB)
Install:
- new gasket for the throttle body (TB)
CAUTION: Tighten the screws crosswise. the throttle body (TB) using new screws.
Connect the connector to the throttle body (TB).
Installing components
Connect the battery ground lead.
Install the air cleaner (ACL) module.
Finishing
Final checks
Test drive the engine and check the function.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.