Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007V50 L5-2.4L VIN 38 B5244S4REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRREAR DOOR MODULE (RDM)
2007 Volvo V50 L5-2.4L VIN 38 B5244S4
Rear Door Module (RDM)
2007 Volvo V50 L5-2.4L VIN 38 B5244S4SECTION Rear Door Module (RDM)
Rear Door Module (RDM)
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
Preparatory work
Information
Caution! Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the cause of the fault.
Ignition off
Ignition off
Removal
Removing the left rear door module (LDM) / right rear door module (RDM)
Caution! The control modules and electric motor may not be parted.
Remove the control module and electric motor according to: Electric motor, lift mechanism, rear door Service and Repair.
Installation
Installing the left rear door module (LDM) / right rear door module (RDM)
Caution! Check that the control module connectors are intact.
Fit the control module and electric motor according to: Electric motor, lift mechanism, rear door Service and Repair.
Finishing
Initializing the window position
Initialize the window position, see VIDA vehicle communication.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.