Programming Of Global Opening/Closing Of Windows

2007 Volvo S40 T-5, AWD, AutomaticSECTION Programming Of Global Opening/Closing Of Windows
Fig 1: Identifying Ignition ON
GLL101051Courtesy of VOLVO CARS OF NORTH AMERICA.

There are four programming positions to choose from:Β 

  • Global opening not activated, global closing activated.
  • Global opening not activated, global closing not activated.
  • Global opening activated, global closing activated.
  • Global opening activated, global closing not activated.

Proceed as follows:Β 

  • Ignition on
  • Click on the symbol for VCT2000 to start programming.
  • Select one of the above alternatives.

Check that programming has been successful:Β 

  • Ignition off
  • Remove the ignition key.
  • Try to close and open all windows using the remote control.
Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
GLL100563Courtesy of VOLVO CARS OF NORTH AMERICA.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.