2004 Volvo XC70FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
Alarm Siren (16/35) At inside front of front right wheelwell. See Figure.
Amplifier (16/2) On right side of passenger compartment. See Figure.
Auxiliary Heater (9/30) At left front of vehicle. See Figure.
Battery (1/1) In rear of cargo compartment, under carpet. See Figure.
Bumper Antenna Amplifier (16/67) At right rear corner of cargo compartment. See Figure.
Bumper Antenna (16/68) At right side of rear bumper. See Figure.
Capacitor (20/16) In engine compartment relay/fuse box. See Figure.
Cellular Telephone Antenna (16/64) Front of headliner. See Figure.
Contact Rear (18/4) Top of steering column. See Figure.
Data Link Connector (17/13) Below left side of dash. See Figure.
Generator (6/26) Front of engine. See Figure.
GPS Antenna (16/47) At top left side of dash. See Figure.
Horn 1& 2 (16/10, 16/11) Front of engine compartment. See Figure.
Jump Start Connection (17/17) At left side of engine compartment, forward of strut tower. See Figure.
Road Traffic Information (16/45) Left rear corner of cargo compartment. See Figure.
Spark Plug & Ignition Coil (20/3 - 20/8) Top of engine. See Figure.
T/V Receiver (16/36) Left rear corner of cargo compartment. See Figure.
Window Antenna Amplifier 1 (Left) (16/16) Above left rear window. See Figure.
Window Antenna Amplifier 1 (Right) (16/71) Above right rear window. See Figure.
Window Antenna Amplifier 2 (Left/Right) (16/73, 16/74) Above respective rear windows. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.