2004 Volvo XC70FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G31/1 At rear of right fender. See Figure.
G31/2 At rear of left fender. See Figure.
G31/3 At rear center of cargo compartment. See Figure.
G31/4 At rear left side of engine. See Figure.
G31/6 At left kick panel. See Figure.
G31/10 At right kick panel. See Figure.
G31/44 At left front of engine compartment. See Figure.
G31/46 At left rear of passenger's compartment, near floor. See Figure.
G31/47 At left rear of passenger's compartment, near floor. See Figure.
G31/48 At right rear of passenger's compartment, near floor. See Figure.
G31/53 Left side of engine compartment. See Figure.
G31/66 Below driver's seat, near rocker panel. See Figure.
G31/67 Below passenger's seat, near rocker panel. See Figure.
G31/70 Left front corner of engine compartment. See Figure.
G31/72 At left rear of passenger's compartment, near floor. See Figure.
G31/73 At right rear of passenger's compartment, near floor. See Figure.
G31/83 At left kick panel. See Figure.
G31/84 At right kick panel. See Figure.
G31/88 At top of engine, near spark plugs. See Figure.
G31/89 At top of engine, near spark plugs. See Figure.
G31/91 At left side of engine. See Figure.
G31/93 At rear of left fender. See Figure.
G31/94 At rear of right fender. See Figure.
G31/95 At rear of left fender. See Figure.
G31/96 At rear of right fender. See Figure.
G31/98 At front center of headliner. See Figure.
G31/99 Above left rear window. See Figure.
G31/102 Behind left corner of front bumper. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.