2004 Volvo S40 LSEFACTORY OEM SERVICE PROCEDURE

Test Driving Cars Model Year 2002

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2011 Volvo V50, 2010 Volvo V50, 2009 Volvo V50, 2008 Volvo V50, and 2007 Volvo V50. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Drive where other traffic will not be disrupted.

The car must first be calibrated  and then test driven if work is carried out on any vital components in the DSTC-system (steering wheel angle sensor, control module DSTC, control module steering angle sensor, brake pressure sensor (1 and 2), power brake booster or active yaw control sensor). Calibrating is carried out using VIDA (Volvo scan tool).

When calibrating in the workshop, position the car on a flat surface with the wheels pointing forward. Turn the steering wheel with the ignition turned on at least 15° to the right or left. Then turn the steering wheel to the center position and start calibrating.

The test drive must include at least one right and one left turn (more than 45°), cover at least 100 meters and a braking from 50 km/h to a standstill.

The car has passed the test if the dynamic stability and traction control (DSTC) system does not light any lamps (the traction control lamp, the ABS warning lamp or the general brake warning lamp).

Calibrate and test drive as above if any work that may have affected the steering and /or the wheel alignment (straight ahead position) has been carried out.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.