2004 Volvo S40 LSEFACTORY OEM SERVICE PROCEDURE

Collision Warning Control Module: Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2011 Volvo V50, 2010 Volvo V50, 2009 Volvo V50, 2008 Volvo V50, and 2007 Volvo V50. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Removal steps in this procedure may contain installation details.

Remove the combined instrument panel, see COMBINED INSTRUMENT PANEL

Fig 1: View of Collision Warning Control Module
GLL162576Courtesy of ABLE BODY CORP.

Torque:Β  M6

10 Nm

Fig 2: Removing Collision Warning Control Module
GLL162577Courtesy of ABLE BODY CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.