2004 Volvo S40 LSEFACTORY OEM SERVICE PROCEDURE

Removing the Control Module

Fig 1: Identifying Control Panel Screws
GLL117163Courtesy of VOLVO CARS OF NORTH AMERICA.
  • Remove the 3 screws
  • Disconnect the connectors
  • Removing the control panel.
Fig 2: Dashboard Environment Panel
GLL117164Courtesy of VOLVO CARS OF NORTH AMERICA.
  • Remove the 2 screws. Move the heater unit downwards at an angle
  • Disconnect the green connector (GN)
  • Remove the air hose
  • Remove the heater unit.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.