Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic trouble code (DTC) information
Condition
Diagnostic trouble code (DTC) BCM-0050 is stored if the brake control module (BCM) registers an internal fault, such as distortion or an open-circuit in the circuit for the hydraulic valves.
Substitute Value
- The ABS is blocked
- Electronic Brake force Distribution is blocked
- Stability control is blocked
- Traction control is blocked
- Active yaw control is blocked
- Brake assistance is blocked.
HINT: For information about brake system abbreviations, see Brake system, abbreviations .
Possible Source
- Interference that has affected control module calculations
- Internal fault in the control module.
Fault symptom[s]
- General warning lamp lit
- The ABS warning lamp is lit
- The warning lamp for brake circuit not functioning is lit
- The anti-spin warning lamp is lit (up to and including 2002 model year)
- The ABS system does not function
- Anti-spin does not function
- The stability control system does not function
- The traction control system does not function.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.