Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic trouble code information
Condition
If the ABS control unit discovers that the checksum does not correspond when storing adaptive data in the control unit, s EEPROM memory, diagnostic trouble code ABS-00C4 will be stored.
Substitute Value
- Stabilizing function not working
Possible Source
- Faults in the control unit memory circuit
- Voltage too low
Fault symptom[s]
- Anti-spin warning lamp is on.
- Anti-spin function not working.
- Stabilizing function not working.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.