Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Checking cables
Check that the communication cables between the control modules are not too close to sources of interference such as electric motors, ignition cables and carphone cables.
Check communication wiring between control modules for an intermittent open-circuit according to Open-circuit, intermittent faults , an intermittent short-circuit to ground according to Short-circuit to ground, intermittent faults and an intermittent short-circuit to supply voltage according to Short-circuit to supply voltage, intermittent faults .
Remedy as necessary.
Other information:
- For further information about the wiring and terminals, see the appropriate wiring diagram.
- Continue
Refer to Information
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.