Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003XC70REPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSDRIVER DOOR MODULE (DDM) & PASSENGER DOOR MODULE (PDM) DIAGNOSTIC TROUBLE CODES (XC) - 1 OF 2DDM/PDM-0007 POWER WINDOW UP RELAY. FAULTY SIGNAL (2001-2002)DIAGNOSTIC TROUBLE CODE INFORMATION
2003 Volvo XC70
Diagnostic trouble code information
2003 Volvo XC70SECTION Diagnostic trouble code information
Condition
If control unit registers that signal wire voltage for raising window is low when the switch is activated, diagnostic trouble code DDM/PDM-0007 is displayed.
Substitute Value
- Nothing.
Possible Source
- Window lift relay RL1 UP locked in inactivated position.
Fault symptom[s]
- Electric window lift does not work.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.