Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Checking the cable
- Ignition on.
- Try to activate the motor.
HINT: The resistance between #1D and #2D must be approximately 0 Ξ©.Β
Check the cable between the power seat module (PSM) #2D and the motor for an open-circuit according to Open-circuit, permanent faults .
Remedy as necessary.
If no fault is found try replacing the motor.
Other information:Β
- To connect the breakout box, see Connecting the breakout box, power seat module (PSM) .
- For information about signals, see Output signals to the motors .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.