Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003V70 2.4 L5-2.4L VIN 61 B5244SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSTCM CODES (TRANSMISSION CONTROL MODULE)TCM-001FDIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244S
Diagnostic Trouble Code (DTC) Information
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
Diagnostic trouble code (DTC) TCM-001F is stored if the control module registers that the signal from the speed sensor is missing.
Substitute value
- None.
Possible source
- Contact resistance in the terminals.
- Open-circuit in the power supply.
- Open-circuit in the signal cable.
- Defective speed sensor.
Fault symptom[s]
- General orange warning lamp lit.
- Malfunction indicator lamp (MIL) lit.
- No lock-up function.
- Harsh gear shifting.
Hint: Harsh gear shifting can be caused by:
- No reduction of the line pressure when shifting.
- No reduction of the line pressure when moving the gear selector between positions P-R, N-R and N-D.
- No request for torque limiting to the engine control module (ECM) when shifting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.