Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003V70 2.4 L5-2.4L VIN 61 B5244SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSSAS CODES (STEERING WHEEL ANGLE SENSOR MODULE)SAS-0046INTERMITTENT FAULTNO SIGNAL
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244S
No Signal
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244SSECTION No Signal
No signal. Intermittent fault
Checking the wiring and connections
Check the wires between steering wheel angle sensor (SAS) control unit #4 (#A28) and steering wheel control unit (SWM) #3 (#A3) for an open circuit, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Additional information:
- To connect the test box to the steering wheel angle sensor (SAS), see Connecting the breakout box to the steering angle sensor Connecting the Breakout Box, Steering Wheel Angle Sensor Module (SAS).
- To connect the test box to the steering wheel control unit (SWM), see Connecting the breakout box Connecting the Breakout Box, Steering Wheel Module (SWM).
- For information on signals, see Signal description, Control unit for the steering wheel angle sensor (SAS) Signal Specification and Signal specification Signal Specification, Steering Wheel Module (SWM).
Continue - Trouble-shooting information
-------------------------------------------------
Trouble-shooting information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - Checking the wiring and connections
FAULT FOUND - Fault Found
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.