Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003V70 2.4 L5-2.4L VIN 61 B5244SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSSAS CODES (STEERING WHEEL ANGLE SENSOR MODULE)SAS-0005INTERMITTENT FAULTDIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244S
Diagnostic Trouble Code (DTC) Information
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code information
Condition
The steering wheel angle sensor has two circuits each with 4 LEDs and 4 receptors which read off their individual track on a perforated code disc. One circuit measures the steering wheel angle and the other measures steering wheel revolutions. If the control unit registers that the signal for any of the steering wheel angle signals A, B, IX, IY, R1, R2, R3 or R4 is too high, diagnostic trouble code SAS-0003, 0005, 0007, 0009, 0011, 0013, 0015 or 0017 is set, depending on the steering wheel angle signal.
Substitute value
- Stabilising function disconnected.
- Anti-spin function blocked.
Possible source
- Contact resistance or oxidation in connections or connectors.
- Short circuit to voltage supply.
- Open circuit.
- Defective control unit.
Fault symptom[s]
- Anti-spin warning lamp is on.
- Stabilising function not working.
- Anti-spin does not work.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.