Diagnostic Trouble Code (DTC) Information

2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244SSECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information

Condition
After the ignition has been switch off, the engine control module (ECM) carries out internal checks. When the checks are complete, after approximately 2 minutes, the engine control module (ECM) interrupts the activation of the system relay coil. Diagnostic trouble code (DTC) ECM-820A is stored in the engine control module (ECM) if the system relay is active when the engine control module (ECM) has interrupted the activation of the system relay coil.

Substitute value
None.

Possible source

Faulty signal:
- short-circuit to ground in signal cable
- defective system relay
- short-circuit to supply voltage in the power cable.

Fault symptom[s]
None.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.