Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003V70 2.4 L5-2.4L VIN 61 B5244SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-8010CHARGED TOO LONG
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244S
Charged Too Long
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244SSECTION Charged Too Long
Charged too long
Checking the charge voltage
- Start the engine.
- Connect a voltmeter between the battery terminals.
Battery voltage should be over 16 V.
Is the battery voltage OK?
Yes - Intermittent fault
No - Checking the charging system
-------------------------------------------------
Checking the charging system
Check the charging system for too low charging voltage.
Continue - Fault-tracing information
-------------------------------------------------
Intermittent fault
- Check the control module's connector as well as the battery's and alternator's connections for loose connections, contact resistance, and oxidation according to: Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
- Check the cable connection of fuse 11B/1 for contact resistance and oxidation according to: Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - Checking the charge voltage
FAULT FOUND - DONE
DONE - DONE
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.