Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003V70 2.4 L5-2.4L VIN 61 B5244SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-4320DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244S
Diagnostic Trouble Code (DTC) Information
2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-4320
Condition
The engine control module (ECM) checks the control signal to the reset valve in the leak diagnostic pump.
The diagnostic trouble code (DTC) is stored if the engine control module (ECM) registers a fault in the control signal to the reset valve in the leak diagnostic pump.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.
Substitute value
- The leak diagnostic is cancelled.
Possible source
Signal too high
- Short-circuit to supply voltage in the signal cable
- Damaged leak diagnostic pump.
Signal too low
- Short-circuit to ground in the signal cable
- Open-circuit in the signal cable
- Damaged leak diagnostic pump.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.