Diagnostic Trouble Code (DTC) Information

2003 Volvo V70 2.4 L5-2.4L VIN 61 B5244SSECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information ECM-1000

Condition




The diagnostic trouble code (DTC) is stored if the engine control module (ECM) registers an internal fault indicating that the signal from the internal atmospheric pressure sensor is incorrect.
The diagnostic trouble code (DTC) can be diagnosed when the ignition has been on for at least 15 seconds.

Substitute value
- If the pressure sensor to the intake manifold is OK, a filtered value from the sensor is used. Otherwise the value is set at 1,013 hPa (corresponding to sea level).

Possible source
- Damaged engine control module (ECM).

Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.