SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003S80 T-6REPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSELECTRICAL ACCESSORIES - DESIGN AND FUNCTIONCLIMATE CONTROL MODULE (CCM) (2005-2006)DESIGNDAMPER MOTOR MODULE (DMM)
2003 Volvo S80 T-6

Damper motor module (DMM)

2003 Volvo S80 T-6SECTION Damper motor module (DMM)
Fig 1: Damper Motor Module
GLL140253Courtesy of VOLVO CARS OF NORTH AMERICA.

The damper motor module (DMM) consists of a control unit and a stepper motor. The different versions of the climate control system have up to 5 damper motor modules (DMM). These are for the different functions such as defroster and recirculation. The climate control module (CCM) communicates with the other damper motor modules (DMM) via two LIN buses, LIN bus 1 and LIN bus 2. The position of the damper motors on the LIN buses depends on whether the vehicle is left or right-hand drive.

When regulating the different dampers, the climate control module (CCM) transmits a request for a new damper position to the each damper motor module (DMM). The damper motor module (DMM) calculates and then regulates the required direction and number of steps required to obtain the requested position. The damper motor module (DMM) then transmits information to the climate control module (CCM) indicating the actual damper position and status.

When replacing the damper motor module (DMM), the new damper motor must be identified by the climate control module (CCM). This is carried out via VIDA. When replacing the damper motors, ensure that identification is carried out.

Each damper motor module (DMM) is powered via a relay in the central electronic module (CEM).

There are diagnostics for the damper motor module (DMM).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.