Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic trouble code (DTC) information ECM-612D
Condition
The engine control module (ECM) checks the signal cable for the reset valve for the intake camshaft.
The diagnostic trouble code (DTC) is stored if the engine control module (ECM) detects that the signal from the signal cable for the reset valve is too low.
The diagnostic trouble code (DTC) can be diagnosed at ignition on and with the engine running.
Substitute Value
- None.
Possible Source
- Contact resistance in the terminals
- Short-circuit to ground in the signal cable
- Damaged camshaft reset valve.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.