Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel trim: Notes
Control of the fuel/air mixture occurs following known principles. However the signal from the front probes are of a more linear character. This means that the Engine Control Module (ECM) notices small changes throughout the voltage range and can control the fuel/air mixture much faster and more precisely than before.
6 cylinder engines have been equipped with double catalytic converters. Each catalytic converter serves three cylinders.
The heated oxygen sensors (HO2S) contain as before a PTC resistor which is supplied with voltage from the Engine Control Module (ECM) in order to reach operating temperature quickly. The oxygen sensitive ceramic which measures oxygen levels in the exhaust gases consists of Zirconium dioxide.
If the Engine Control Module (ECM) determines that the ambient air is very cold and damp it may delay starting to heat up the heated oxygen sensors (HO2S) a few seconds. This is to prevent the heated oxygen sensor (HO2S) warm ceramic being touched by cold drops of water and then cracking.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.