Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2003S60 2.4 L5-2.4L VIN 61 B5244SREPAIR AND DIAGNOSISMAINTENANCEWHEELS AND TIRESWHEEL HUBSERVICE AND REPAIRFRONT WHEEL HUB, REPLACING
2003 Volvo S60 2.4 L5-2.4L VIN 61 B5244S
Front Wheel Hub, Replacing
2003 Volvo S60 2.4 L5-2.4L VIN 61 B5244SSECTION Front Wheel Hub, Replacing
Replacing the front wheel hub
Special tools:
951 2050 BEVEL PROTRACTOR 951 2050 Bevel Protractor
Removing the front wheel hub
- Remove the wheel spindle. See Wheel spindle, replacement Removal and Replacement
- Place the wheel spindle in a soft jawed vice.
Remove
- the four screws holding the hub to the wheel spindle
- the hub.
Installing the front wheel hub
Note! Ensure that the hub and the wheel spindle mating surfaces are clean.
- Install the hub. Usenew screws
- Tighten crosswise. Tighten to 20 Nm. Then tighten to 65 Nm. Finally angle-tighten 60°. Use bevel protractor 951 2050 BEVEL PROTRACTOR 951 2050 Bevel Protractor
- Install the wheel spindle. See Wheel spindle, replacement Removal and Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.