Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO1994940 BASE, 4D SEDAN, AW71REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC DIAGNOSTIC PROCEDURESFUEL SYSTEMFUEL PRESSUREFUEL PUMP CIRCUIT (940)
1994 Volvo 940 Base, 4D Sedan, AW71
Fuel Pump Circuit (940)
1994 Volvo 940 Base, 4D Sedan, AW71SECTION Fuel Pump Circuit (940)
- Remove fuel injection system relay. Check voltage at terminal No. 30. See Figure and Figure . If battery voltage does not exist, repair wiring between relay connector and battery.
- Connect jumper wire between terminals No. 30 and 87/2 of fuel injection system relay connector. Fuel pump should run. If fuel pump does not run, check wiring between pump and relay. Also check wiring between terminals No. 87/1 and 85 for continuity. Repair as necessary.
NOTE:
ECU terminal identifications are marked on unit or connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.