SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO1993940 TURBO, 4D SEDAN, AW71REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSTECHNICAL BULLETINSTECH TIPSSTEERING LINKAGEALIGNMENT ALERT (VOL0253AP)
1993 Volvo 940 Turbo, 4D Sedan, AW71

Alignment Alert (VOL0253AP)

1993 Volvo 940 Turbo, 4D Sedan, AW71SECTION Alignment Alert (VOL0253AP)
Publication date: 1997-03-01
Reference number: VOL0253AP

ALIGNMENT ALERT

ALIGNMENT ALERT

TECHNICAL INFORMATION TIP

Reference Number(s): VOL0253AP, Date of Issue:  March 1997

VOLVO ALIGNMENT ALERT

YEAR(S): 1975-94

MANUFACTURER: Volvo

DATE OF ISSUE: March 1997

ISSUE & TIP

If you are aligning a 1975-94 Volvo, check the angle of the ball joints carefully. I found a caster angle to be way out of specs and not adjustable, but the camber was okay.

The solution: the right and left side ball joints are interchangeable. You can put two right side ball joints on and have a two degree negative difference on the left side caster due to the offset.

I spent an hour looking for something that was bent, when the problem was that our do-it-yourselfer was sold two right side ball joints and in-stalled them with three bolts holding them in place.

Courtesy of Import Service Magazine

with thanks to:

Bill Restoff

Dobbs Tire and Auto Centers

Fairview Heights, Illinois

REFERENCE NUMBER

VOL0253AP

NOTE: This information has been obtained from sources generally believed to be reliable. Use your own judgment before relying on this data. Neither the suppliers of these Technical Information Tips, nor lemon-25 Repair Information Company, LLC, guarantees or assumes responsibility for data accuracy or completeness, nor is liability assumed by the suppliers of these Technical Information Tips or lemon-25 Repair Information Company, LLC, for any claims or damages resulting from the use of this information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.