Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO1993940 TURBO, 4D SEDAN, AW71REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM/COMPONENT TESTSFUEL SYSTEMFUEL CONTROLFUEL INJECTORS (TURBO)
1993 Volvo 940 Turbo, 4D Sedan, AW71
Fuel Injectors (Turbo)
1993 Volvo 940 Turbo, 4D Sedan, AW71SECTION Fuel Injectors (Turbo)
- Remove auxiliary relay, located on left front fender panel. Jumper relay terminals No. 2 (Blue/Yellow wire) and No. 3 (Green/Red wire). Connect ohmmeter between fuel injection ECU terminals No. 9 and 18. Fuel injection terminal identification is marked on connector. Resistance should be 2.25 ohms. If resistance is 2.9 ohms, one injector or wire is faulty.
- If resistance is 4.4 ohms, 2 injectors or wires are faulty. If resistance is 8.5 ohms, 3 injectors or wires are faulty. To check injectors individually, disconnect injector wires and connect ohmmeter between suspected injector terminals. Resistance should be 2 ohms. Replace as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.