Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Preliminary Checks
1993 Volvo 940 Turbo, 4D Sedan, AW71SECTION Preliminary Checks
- Turn ignition switch to OFF position. Disconnect fuel injection ECU connector. Fuel injection ECU is located on right side of instrument panel, under kick panel. Push out clip and disconnect ECU connector.
- Remove cover from ECU connector to expose terminal identification numbers. Visually inspect all terminal connector sleeves to ensure all terminals are at same height.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.