Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO1993940 TURBO, 4D SEDAN, AW71REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICAL2.3L 4-CYL & 2.3L 4-CYL TURBOTORQUE SPECIFICATIONS
1993 Volvo 940 Turbo, 4D Sedan, AW71
Torque Specifications
1993 Volvo 940 Turbo, 4D Sedan, AW71SECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| Camshaft Bearing Cap Bolt (1) | 15 (20) | |||||||||
| Camshaft Sprocket Bolt | 37 (50) | |||||||||
| Connecting Rod Cap Bolt (1)(2) | ||||||||||
| Step 1 | 14 (19) | |||||||||
| Step 2 | Additional 90 Degrees | |||||||||
| Crankshaft Pulley Bolt (1) | ||||||||||
| Step 1 | 44 (60) | |||||||||
| Step 2 | Additional 60 Degrees | |||||||||
| Cylinder Head Bolt (1)(3) | ||||||||||
| Step 1 | 14 (19) | |||||||||
| Step 2 | 43 (58) | |||||||||
| Step 3 | Additional 90 Degrees | |||||||||
| Exhaust Pipe-To-Turbo Bolt | 22 (30) | |||||||||
| Flywheel Or Drive Plate Bolt (4) | 51 (69) | |||||||||
| Intermediate Shaft Sprocket Bolt | 38 (51) | |||||||||
| Main Bearing Cap Bolt (1) | 80 (110) | |||||||||
| Torque Converter-To-Drive Plate Bolt | 30-38 (41-51) | |||||||||
|
||||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.