Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO1993850 L5-2.4L VIN 55 B5254SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSABS CODES (ANTILOCK BRAKE SYSTEM CONTROL MODULE)DTC 4-4-3 [EL]PROCEDURESCHECKING SUPPLY [EL5]
1993 Volvo 850 L5-2.4L VIN 55 B5254S
Checking Supply [EL5]
1993 Volvo 850 L5-2.4L VIN 55 B5254SSECTION Checking Supply [EL5]
Checking Supply
- Ignition off.
- Connect combination relay 15-pin connector.
Connect a voltmeter between combination relay 15-pin connector terminal 15 and ground.
Voltmeter should read approx. battery voltage.
If reading is OK:
- Checking supply to pump motor EL6. Checking Supply to Pump Motor [EL6]
If reading is incorrect:
- Check fuse 11/9 for open circuit.
- If fuse is OK, check lead between combination relay connector terminal 15 and fuse 11/9 for open circuit as per HA2. Open Circuit [HA2]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.