Wheel Alignment Specifications

1992 Volvo 240 Base, 4D Sedan, Automatic, AW70LSECTION Wheel Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS

Application Preferred Range
Camber (1)
Front .5 .25 To .75
Caster (1) 3.5 3 To 4
Toe-In (2)
Front .13 (3.5) .07 To .2 (2 To 5)
Toe-In (1)
Front .27 .13 To .4
Toe-Out On Turns (1)
Inner 20.8 N/A
Outer 20 N/A
(1) Measurement is in degrees.
(2) Measurement is in inches (mm).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.