Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO1991240 BASE, 4D WAGON, AUTOMATIC, AW70LREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROLS - ADJUSTMENTSTHROTTLE CONTROLSKICKDOWN CABLE
1991 Volvo 240 Base, 4D Wagon, Automatic, AW70L
KICKDOWN Cable
1991 Volvo 240 Base, 4D Wagon, Automatic, AW70LSECTION KICKDOWN Cable
NOTE:
Depress accelerator pedal. DO NOT
turn throttle pulley by hand or an incorrect adjustment will result.
Fully depress accelerator pedal. At full throttle, distance between cable stop and cable casing should be 1.98-2.07" (50.4-52.6 mm). See Fig 1 . Adjust kickdown cable if not within specification.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.