Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO1987760 GLE, 4D WAGON, AW71REPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONMAINTENANCE REMINDER LIGHT (RESET PROCEDURES)MAINTENANCE SERVICE REMINDERMAINTENANCE SERVICE REMINDER RESET - PROCEDURE 15DIGITAL INSTRUMENT PANEL
1987 Volvo 760 GLE, 4D Wagon, AW71
Digital Instrument Panel
1987 Volvo 760 GLE, 4D Wagon, AW71SECTION Digital Instrument Panel
- Switch ignition to position I.
- Press and hold in the OK button on the end of left steering wheel stalk.
- Switch ignition to position II, while continuing to press OK button.
- Wait for 10 seconds.
- Release the button when the information light starts to flash.
- The instrument beeps when resetting has been successful.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.