Cylinder Block Specifications

1987 Volvo 240 GL, 4D Sedan, Automatic, AW70SECTION Cylinder Block Specifications
WARNING: This page is about a different car, the 1991 Volvo 940, 1991 Volvo 740, and 1991 Volvo 240. However, it is still accessible from the selected car via links, so may be relevant.
CYLINDER BLOCK SPECIFICATIONS

Application In. (mm)
Cylinder Bore
Diameter
Standard "C" (1) 3.7795-3.7799 (96.00-96.01)
Standard "D" (1) 3.799-3.803 (96.01-96.02)
Standard "E" (1) 3.7803-3.7807 (96.02-96.03)
Standard "G" (1) 3.,7811-3.7815 (96.04-96.05)
Oversize "1" (1) 3.7913 (96.3)
Oversize "2" (1) 3.8031 (96.6)
Maximum Taper & Out-Of-Round .004 (.10)
Minimum Deck Height (2)
Maximum Deck Warpage (2)
(1) Cylinder bore diameter is indicated by letter or number stamped on deck surface.
(2) Information is not available from manufacturer.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.