Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Condenser, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Replace the seals. Refer to the Parts Information for the versions.
-- If the condenser is replaced, 10 % of the total capacity of refrigerant oil must be filled in the installed A/C compressor in the refrigerant circuit. Refer to TECHNICAL DATA .
-- Coat the new seals with refrigerant oil before installing the refrigerant line.
There is a risk of damaging the A/C compressor if the refrigerant circuit is empty.
- Never start the engine with the refrigerant circuit empty.
Vehicles with Refrigerant R134a
-- Fill the refrigerant circuit. Refer to Working with A/C Service Station .
-- Perform the leak test on the refrigerant circuit line connections that were closed again. Refer to Refrigerant Circuit, Detecting Leaks .
Vehicles with Refrigerant R1234yf
-- Charge the refrigerant circuit. Refer to Working with A/C Service Station (1 Of 2) / Working with A/C Service Station (2 Of 2) .
-- Perform the leak test on the closed line connections of the refrigerant circuit. Refer to LEAKS, FINDING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.