Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Belt Pulley, Removing And Installing, SANDEN A/C Compressor
The belt pulley is sensitive to impact, for this reason handle it especially carefully.
If the overload protection of the belt pulley is tripped, check the A/C compressor for ease of movement, before replacing the belt pulley. Replace an A/C compressor that is not operating smoothly.
If the drive plate overload protection was activated, the belt pulley can be rotated using the outer part of the drive plate so that the A/C compressor shaft and the hex fitting on the drive plate (inner part of the drive plate) do not rotate.
-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .
-- Belt Pulley, Removing and Installing. Refer to OVERVIEW - BELT PULLEY, SANDEN A/C COMPRESSOR .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.