Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Peripheral Camera Control Module -J928-, Removing And Installing: Removing
-- Raise the front seat into its highest position and then move it all the way back.
-- Turn off the ignition and all electrical equipment.
-- Move the ignition key outside of the vehicle to prevent switching on the ignition unintentionally.
-- Remove the expanding rivets -arrows-.
-- Push the cover -1- with the peripheral camera control module, straight in the direction of travel, while paying attention to the connected wires and turn.
-- Release and disconnect the connectors -3-.
-- Release the catches on the cover -1- in the direction of the -arrows-.
-- At the same time remove the control module -2- from the cover -1-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.