Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSVOLKSWAGEN2022ID.4 PRO, AWDREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSAIR CONDITIONING87 AIR CONDITIONINGFRONT HEATER AND A/C UNITOVERVIEW - HEATER AND A/C UNIT AIR INTAKE HOUSING

2022 Volkswagen ID.4 Pro, AWD

Overview - Heater And A/C Unit Air Intake Housing

2022 Volkswagen ID.4 Pro, AWDSECTION Overview - Heater And A/C Unit Air Intake Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Fresh Air Intake Cover
Fresh Air Intake
- Refer to Fresh Air Intake, Removing and Installing .
Bolt
- Pay attention to the tightening sequence. Refer to Air Shroud, Removing and Installing .
- Quantity: 3
- 8 Nm
Air Shroud
- Refer to Air Shroud, Removing and Installing .
Nut
- Pay attention to the tightening sequence. Refer to Air Shroud, Removing and Installing .
- Quantity: 7
- 8 Nm
Bolt
- Quantity: 4
- 2 Nm
Cap
Bolt
- Quantity: 3
- 2 Nm
Fresh Air Blower Control Module -J126-
- Refer to Fresh Air Blower Control Module -J126-, Removing and Installing .
Heater and A/C Unit Air Intake Housing
- Refer to Heater and A/C Unit Air Intake Housing, Removing and Installing .
Nut
- Quantity: 5
- 4 Nm
Bolt
- Refer to OVERVIEW - ADJUSTMENT MOTORS, PR NUMBER KC0, KH4 / OVERVIEW - ADJUSTMENT MOTORS, PR NUMBER KH7 .
Actuator for Fresh and Air Recirculation Door -VX96-
- With Fresh Air/Recirculating Air/Back Pressure Door Motor -V425-
- With the Fresh Air/Recirculating Air/Back Pressure Door Motor Position Sensor -G644-
- Refer to ACTUATOR FOR FRESH AND AIR RECIRCULATION DOOR -VX96-, REMOVING AND INSTALLING .
Noise Insulation
Dust and Pollen Filter
- Refer to Dust and Pollen Filter, Removing and Installing .
Dust and Pollen Filter
- Depending on equipment/version
- Refer to Dust and Pollen Filter, Removing and Installing .
Cover
Bolt
- Depending on equipment/version
- 2 Nm
Noise Insulation
Seal
Seal

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.