Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
End Panel, Removing And Installing: Removing
-- Remove the door. Refer to Door, Removing and Installing .
-- Remove the front wheel housing liner. Refer to Front Wheel Housing Liner, Removing and Installing .
-- Release the hook -2-.
-- Remove the end panel -1- at the top slightly in the -direction of the arrow A- from the fender -3- and remove in the -direction of the arrow B-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.