Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Peripheral Camera Control Module J928, Removing And Installing: Removing
If the Control Module Is Replaced, the Test Plan for Replacing the Control Module Must Be Performed.
-- Perform the function "peripheral camera control module, replacing" using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .
Continuation
-- Remove the seat pan. Refer to SEAT PAN, REMOVING AND INSTALLING .
-- Disconnect the connectors.
-- Loosen the expanding rivets -2- and remove the control module -1-.
-- Remove the Peripheral Camera Control Module - J928-. Refer to Peripheral Camera Control Module J928, Removing and Installing .
-- Remove the nuts -1-.
-- Remove the bracket.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.