Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Threaded Bushing, Removing And Installing: Installing
Install in reverse order of removal while noting the following:
Always drive out the threaded bushing from above in the direction of the steering shaft.
-- Insert the threaded bushing in straight.
-- Drive in the threaded bushing until stop.
-- Position the steering gear -1- on the subframe.
-- Insert the steering gear threaded sleeves -2- in the subframe holes -arrow-.
-- For vehicles with a level control system sensor, perform the basic setting using the Vehicle Diagnostic Tester.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.